Tutorials
Step-by-step guides for connecting a device and getting its data into inMotion. Each follows one scenario from initial setup through to inMotion Studio. These are in preparation. Getting Started and the Data Platform page cover the essentials in the meantime.
Planned Tutorials

A Custom BLE Sensor for inMotion Track

Capture surface roughness with inMotion Track paired to a custom vibration sensor. Build the sensor, connect it over Bluetooth, and see its readings alongside your track.

Coming soon

A Weather Station Straight to inMotion over MQTT

Send readings from a weather station straight to inMotion over the internet. Set up the device, connect it to the cloud, and watch live conditions build up on a map.

Coming soon

The Same Weather Station via a Local Data Logger

Run the same weather station through the Data Logger on a local gateway. Keep recording when the connection drops and send everything on once it is back.

Coming soon
Community Examples

ESP32 NMEA 0183 BLE Bridge

Bridge an NMEA 0183 marine GPS to inMotion Track over Bluetooth using an ESP32 and an RS232-to-TTL converter - firmware, wiring diagram, BLE protocol reference, device config, and a bundled GPS simulator (no boat or real GPS fix required to try it) all included.

source and examples on GitHub
For an early draft, or to suggest a scenario, contact us.